HAL-506 HAL-506S Hall speed sensor

Overview

HAL-506 HAL-506S Hall speed sensor is a small enclosed sensor with the advantages of stable performance, low power consumption, strong anti-interference ability, and wide operating temperature range. The principle is that when the lines of magnetic force pass through the sensing element on the sensor, the Hall potential is generated after being amplified and shaped by the Hall chip, and then a force electrical signal is used by the secondary instrument. When in use, just stick a small magnetic steel on the rotating object, fix the sensor within a certain distance from the magnetic steel, and align the S pole of the magnetic steel to perform measurement.

Main tech data

HAL-506 HAL-506S Hall speed sensor

Measuring range: 1Hz~45KHz

Output mode: low-level effective, drive capacity is not less than 15mA

Output signal: Waveform: Rectangular wave

Amplitude: High level is close to the power supply, low level ≤0.5V

Power supply: (4.5~24) VDC, (12~18) V maximum value

Number of pulses per revolution: the same as the number of magnets attached

Detection distance: ≤4mm

Normal working conditions

Temperature: -20℃~+80℃

Relative humidity: no more than 85%

Atmospheric pressure: 86KPa~106KPa

         No explosive or corrosive gas around

External thread: M12×1

Effective length of thread: L, L=50, 75, 100mm

Output wire: 2m

Note: Any special design or question of HAL-506 HAL-506S Hall speed sensor, kindly contact the manufacturer for more details.